A lathe half center is used:
ATo support the work piece always
BTo turn long work piece
CBecause it is easy to lubricate the work piece
DTo face the work piece up to the end of the center hole
No.1 PSC Learning App
★
★
★
★
★
Related Questions:
The system of irrigation in which water is applied to the fields by means of a network of pipes having spray nozzles is
The extent of survey is more than.................. sq.km is taken to account of curvature effect of the earth surface:
An intense rain is falling uniform of 7.5 cm/hour for a period of 60 minutes on a basin whose area is 500 hectares. If the average infiltration capacity during the entire rain period is assumed to be 1.5cm/hour, the maximum run off rate based on 10 minute peak percentage of 16% from distributing graph of the basin is
In a thin cylinder the ratio between circumferential stress to the longitudinal stress is
Maximum velocity of a body moving in SHM occurs when it is at